Team-BHP - View Single Post

ajayclicks · 16th February 2006, 13:47

Hi,

I have a swift - arnd 10 months old and 9000 kms done.

I faced 1 problem in past and 1 recurring problem.

I have autocop and like many other members i too faced the rear door issue. when i took it to my dealer, he was like "actually autocop is not suitaable for swift". this is hilarious coz when i installed autocop from him, i went for the cheapest version while he was tryin to convince me to buy the most exp one!!!!!!! anyways the faulty part in the door was replaced promptly and without charge

The gears suck. 2 services done- ample requests to smoothen/ ease the gears. I think its a design issue. at times i feel like i am driving a truck.
Specifically it wont get into the 3 gear from 2nd and from 2nd to 1st. Mind u this doesnt happen always, but atleast once a week or so. After i struggle with the gear (in the middle of bangalroe traffic) some grinding noise comes (probably ball bearings) then it works smoothly till the next week. As some one said, reverse too is an issue...

No rattling fortunately (not yet anyways)

Ajay

they charge a lot for dents etc- i found a local garage that did a neat job for 4k. the authorised dealers were quoting 11k for the same job.

16th February 2006, 13:47	#54 (permalink)
ajayclicks BHPian Join Date: Feb 2006 Location: Bangalore Posts: 99	Hi, I have a swift - arnd 10 months old and 9000 kms done. I faced 1 problem in past and 1 recurring problem. I have autocop and like many other members i too faced the rear door issue. when i took it to my dealer, he was like "actually autocop is not suitaable for swift". this is hilarious coz when i installed autocop from him, i went for the cheapest version while he was tryin to convince me to buy the most exp one!!!!!!! anyways the faulty part in the door was replaced promptly and without charge The gears suck. 2 services done- ample requests to smoothen/ ease the gears. I think its a design issue. at times i feel like i am driving a truck. Specifically it wont get into the 3 gear from 2nd and from 2nd to 1st. Mind u this doesnt happen always, but atleast once a week or so. After i struggle with the gear (in the middle of bangalroe traffic) some grinding noise comes (probably ball bearings) then it works smoothly till the next week. As some one said, reverse too is an issue... No rattling fortunately (not yet anyways) Ajay they charge a lot for dents etc- i found a local garage that did a neat job for 4k. the authorised dealers were quoting 11k for the same job.