Team-BHP - View Single Post - My Experience With adding Boric Acid in Engine oil

finetuning · 2nd February 2007, 01:02

Hi,
Your initial sluggishness is because of working of powder........but you need to at least dissolve in acetone.....there is no need to add powder direct into sump......

1 table spoon is very less quantity so you need not worry about any ill effect.......infact after 300 km you need to change your oil filter without fail to get best benefit........

Apart from smoothness of running which is because of micro layered boric oxide plates....you will feel very free engine.....but this technique takes time to pass on full benefit..so keep running till 1500 & more km & dont change oil in between.......you can safely change oil after 1500 km........

I used this METAL TREATMENT in at least 40 vehicles without any ill effect & result is just superb.....we need to dissolve in acetone for better result....

If your car hold 3 ltr oil then can add 100 gm dissolving in 100 ml acetone first.......if by any means powder is dissolved then its good idea......

Feeling of smoothness is right............but initially since boric acid tends to seek metal surfaces & starts removing carbons we feel litle loss of power but thats I think not even noticeable...afterwards car engine becomes very smooth.there is gentle hum sound on highways & feeling of gliding......car tends to run with higher gear....do check this.......

2nd February 2007, 01:02	#53 (permalink)
finetuning BHPian Join Date: Mar 2006 Location: Mumbai Posts: 391	Hi, Your initial sluggishness is because of working of powder........but you need to at least dissolve in acetone.....there is no need to add powder direct into sump...... 1 table spoon is very less quantity so you need not worry about any ill effect.......infact after 300 km you need to change your oil filter without fail to get best benefit........ Apart from smoothness of running which is because of micro layered boric oxide plates....you will feel very free engine.....but this technique takes time to pass on full benefit..so keep running till 1500 & more km & dont change oil in between.......you can safely change oil after 1500 km........ I used this METAL TREATMENT in at least 40 vehicles without any ill effect & result is just superb.....we need to dissolve in acetone for better result.... If your car hold 3 ltr oil then can add 100 gm dissolving in 100 ml acetone first.......if by any means powder is dissolved then its good idea...... Feeling of smoothness is right............but initially since boric acid tends to seek metal surfaces & starts removing carbons we feel litle loss of power but thats I think not even noticeable...afterwards car engine becomes very smooth.there is gentle hum sound on highways & feeling of gliding......car tends to run with higher gear....do check this....... Last edited by finetuning : 2nd February 2007 at 01:10.