Quote:
Originally Posted by SumitB  How-to Make a CPU Keychain - Overclockers Club
Have a look. :-)
I quote from the 2nd page of the article.
" Remember, those CPU�s with ceramic PCB�s will crack if drilled too quickly, and also a diamond tip drill bit is required. If you got silicon PCB CPU, any ordinary drill bit will to through it like butter." |
I've visited that site before Sumit, but thanks anyways
I knew that it could be done with a diamond tipped bit but was hoping someone must've done that and could provide me with some tips as in the Indian scenario.
Quote:
Originally Posted by drpullockaran I am a Orthodontist by profession and making holes in ceramics without cracking it is part of our job. Head over to your dentist and ask him to drill a hole in the cpu with a dental air rotor hand piece with a diamond bur. It should not take more than 2 minutes under water spray. If our diamond burs can drill your enamel; drilling ceramics is a piece of cake. Ask him to use a new bur though.
Bye and wear your seat belts. |
Brilliant!! Now were can i find a dentist who's willing to do this for me. And how much does a new diamond bur cost? Maybe i can buy one and present him with the bit and the cpu! I have better chance this way