I see that they have replaced "engine mounts" for your car, maybe they added a layer which absorbs the vibrations and doesn;t transfer them to the chassis, but for doing it they would have to physically remove the engine from the bay and replace the mounts, which looks like a complex and time consuming task or is there a simpler way too?
The judder experienced while moving from stop in 1st gear and also in stop and go traffic is completely gone or reduced?
I don't know about your car, but if you exceed 2.5k rpm, vibrations can be felt in accelerator and clutch pedals. Can you try and share with us if the new setup resolves this issue too?
Thanks in advance |