Team-BHP - View Single Post - My Experience With adding Boric Acid in Engine oil

finetuning · 2nd September 2008, 15:22

Hi,

In pulsar you can add 10gm pure BA with 100ml normal engine oil that you normally use.Mix it well if possible with mixer grinder or hand mixer.Add to engine oil directly from where you add fresh oil in hot engine.You need to bring engine at normal temperature before adding for best benefit.Instantly drive bike without delay for best result up to 30 to 40 minutes without stopping & much pulling.

In your palio you can add 80gm pure BA disolving/mixing with say 300ml normal engine oil that you use.Strill it well as above & pour in hotter engine.Star car & drive for 40 minutes minimum.

Make sure to buy BA from good chemist.Pure powder is very bright,slippery & very fine.

2nd September 2008, 15:22	#351 (permalink)
finetuning BHPian Join Date: Mar 2006 Location: Mumbai Posts: 391	Hi, In pulsar you can add 10gm pure BA with 100ml normal engine oil that you normally use.Mix it well if possible with mixer grinder or hand mixer.Add to engine oil directly from where you add fresh oil in hot engine.You need to bring engine at normal temperature before adding for best benefit.Instantly drive bike without delay for best result up to 30 to 40 minutes without stopping & much pulling. In your palio you can add 80gm pure BA disolving/mixing with say 300ml normal engine oil that you use.Strill it well as above & pour in hotter engine.Star car & drive for 40 minutes minimum. Make sure to buy BA from good chemist.Pure powder is very bright,slippery & very fine.