Merged threads: Pioneer CD-RB10 IP Bus Cable and how to install or splice it.

[low_bass_makker]

Originally Posted by clipto333

im talking about pio hus with aux in. switch on the aux in and select it as the source. im sure it works cause im using it.

lbm, you think its not possible, you are not sure. try it before saying its not possible. i can bet it works

Where do you put the audio input?

From where do you control the volume (from the HU volume control)?

Does the EQ adjustment done change the sound when used in the input ?

If you are using the RCA out for the input then from where does you use
the output ?

Is this setup used for a HU internal amp or external amp ?

What happens when the HU has a single preout only?

[akg7091]

I too don't think it will work. Will check it out tomorrow in my zen. It has an older cassette player from pio with 3 outs and aux in also.
I had the manual lying around with me, and it clearly stated that the aux in is via ipbus.

[clipto333]

lbm,

all i can say is that it works like a normal aux in.

try it out. i dont know about any other pio HU but i have used aux in on more than 4-5 HUs.

my bro has a pio 770mp iirc. he got a wire connected to the radio. so when he switches on the radio, he can play his ipod. i found it strange cause i have used preouts as aux in in the past. then i connected my cd player to the preouts and switched on aux-in and it worked.

i will try it on my 6850 in a while and let you guys know.

cheers
clip

[clipto333]

ok, i tried it on my pio 6850. i connected my discman to the rear preouts source switched to aux1. it was working. the sound was coming from the rear speakers as they are powered by the HU. the amps were connected as well but there was no output from them but the rear speaker were playing.
the volume control of the HU does not work when in aux in(even if connected through the front 2.5mm input).

rajat a.k.a. scary skulls was with me at the time of testing. i think, one can use this if he/she does not have an amplifier.


please try it and let me know the results.

cheers
clip

p.s. please don't blame me if anything happens to the HU. i have never had any problems. and yes, this thing was done in my other cars which didnt have an amplifier. i have never in my life used an aux in in my car. i have always used a cd changer(im using it since the last 8-9 years iirc).

[ScarySkulls]

Yup. i saw it. It works. Discman connected to rear preouts, and there was sound from rear speakers (that are on HU).

Should work fine for guys who dont have amps.
OR
Guys looking for a cheap solution in case even if they have amps. (using high level inputs)

[akg7091]

Strange, but it does work. I tried it on my 7650 cassette player

[clipto333]

Originally Posted by akg7091

Strange, but it does work. I tried it on my 7650 cassette player

so, that means, i have discovered a new hack. but i discovered it 10 years ago iirc. i had a pio cassette HU with 2 pre outs and i just plugged in my discman and it worked. but, it was a hassle to change tracks so i got a cd changer.

cheers
clip

scary,

yes, one can use it with a high to line level converter.

lbm,

you said its not possible. what do you have to say now? :-) no offence. and i wouldn't have said it if i wasn't sure.

cheers
clip

[navin]

Originally Posted by clipto333

so, that means, i have discovered a new hack. but i discovered it 10 years ago iirc. i had a pio cassette HU with 2 pre outs and i just plugged in my discman and it worked. but, it was a hassle to change tracks so i got a cd changer.

I have seen this work when the preouts are NOT buffered. My Alpine 7385 would not allow this however.

[low_bass_makker]

Originally Posted by low_bass_makker

Where do you put the audio input?

From where do you control the volume (from the HU volume control)?

Does the EQ adjustment done change the sound when used in the input ?

If you are using the RCA out for the input then from where does you use
the output ?

Is this setup used for a HU internal amp or external amp ?

What happens when the HU has a single preout only?

Originally Posted by clipto333

lbm,

you said its not possible. what do you have to say now? :-) no offence. and i wouldn't have said it if i wasn't sure.

Sir can you answer the above questions. If you have answered them before then I would have got convinced. as the preout is coming out after the Pre-amp section while going to the HU amplifier. So that is bound to happen. But it might damage the preamp section as you are giving some power to it. and also it is a incorrect way of putting a Aux-in.

One more thing this hack I had done with a old clarion tape HU which used to come with Maruti 800 Deluxe model (1986) I modded the HU in 1992 or 1993 to connect my disk man by soldering the wires after the pre-amp section. And to power on the HU I used a blank cassette.

And you said that with 2.5 mm aux input then also the volume control does not work ?

[navin]

Originally Posted by low_bass_makker

But it might damage the preamp section as you are giving some power to it.

I agree LBM, this is certainly NOT recomended.

[clipto333]

Originally Posted by low_bass_makker

Sir can you answer the above questions. If you have answered them before then I would have got convinced. as the preout is coming out after the Pre-amp section while going to the HU amplifier. So that is bound to happen. But it might damage the preamp section as you are giving some power to it. and also it is a incorrect way of putting a Aux-in.

One more thing this hack I had done with a old clarion tape HU which used to come with Maruti 800 Deluxe model (1986) I modded the HU in 1992 or 1993 to connect my disk man by soldering the wires after the pre-amp section. And to power on the HU I used a blank cassette.

And you said that with 2.5 mm aux input then also the volume control does not work ?

lbm,

i still haven't answered your questions. but you 'now' know what im talking about, right? do i have to convince anyone? was it that difficult to understand? i dont think so. i just said the aux in works when you connect the external source on the rear pre outs.

first you said"it is not possible" and now you are saying "it is bound to happen". what do you want to say? i dont understand why you always disagree. i was sure, thats why i said it works. were you?

and yes, the volume control doesn't work when an external source is connected through the front 2.5mm input but i will confirm again in a while.

cheers
clip