![]() | #31 | |
BHPian ![]() Join Date: Oct 2011 Location: Mumbai
Posts: 158
Thanked: 33 Times
| ![]() Quote:
![]() | |
![]() |
|
![]() | #32 |
BHPian ![]() | ![]() Hi Guys, Just visited 3M at Andheri yesterday. My Swift had it's engine bay coating done when it was new at Vitesse. However, after 5 years the coating had cracked and bubbled and looked terrible. The 3M guys managed to get most of the old stuff off and then re-coated with their engine rejuvenation treatment spray. It took quite a while to get the old stuff off and they did their best. The engine bay now looks much, much better. Lot of attention to detail. The car was totally covered with plastic when doing the treatment to prevent overspray. All in all I was satisfied. 8/10. I also got the power wash done. Again 8/10. They gave a demo of their scratch removal procedure on a rather long scratch on one door. The scratch has gone completely. I also did the A/C treatment. Supposed to clean the A/C system and remove all bacteria. They spray the contents of a can into the A/C vents using a long tube and then start up the blower. Initially it was smelling really nice and fresh but half an hour later the smell was gone. A bit disappointed with that. 6/10. Overall, a good experience. Very clean premises. Staff seem to know what they are doing. Some of their products are definitely a bit costly - viz the A/C treatment cost Rs. 800 for a small can. Regards, SS |
![]() |
![]() | #33 |
BHPian ![]() Join Date: Oct 2011 Location: Mumbai
Posts: 158
Thanked: 33 Times
| ![]() |
![]() |
![]() | #34 |
BHPian ![]() | ![]() Hi Avinash, The address is : Shop No. : 1 A/J/K Shree Laxmi Ashish Industrial Estate Link Road Andheri (West) Bombay 400 053 Tel : Parag : 98206 25784 The Laxmi Industrial Estate entrance is almost exactly opposite the Mercedes show room on the Link Road. When you enter the estate 3M is the first shop on your left - you cannot miss it. Suggest you call and make an appointment before coming all the way from Ghatkopar. Don't forget to mention you are a TBHP member - you MAY get a discount ![]() BTW, I have heard that MKraft in Mulund are pretty good. As that is fairly close to you, have you by any chance dealt with them in the past and if so how is the quality? Rgds, SS |
![]() |
![]() | #35 | |
BHPian ![]() | ![]() Quote:
| |
![]() |
![]() | #36 | |
BHPian ![]() Join Date: Oct 2011 Location: Mumbai
Posts: 158
Thanked: 33 Times
| ![]() Quote:
SS does the place have accessories for detailing like waxes & micro fiber cloth? | |
![]() |
![]() | #37 |
BHPian ![]() | ![]() Hi Avinash & F1Fan, Yes. They have a load of stuff there. All sorts of Meguiar's (3M) products, MF cloths etc. etc. They also do 3M window film at the same place but I found it to be rather expensive - in fact more costly than VKool!! F1Fan, I will take the pics of the engine bay asap and post them for you. Sorry for the delay. Regards, SS |
![]() |
![]() | #38 |
BHPian ![]() | ![]() Hi F1Fan, Attached is a pic of the engine bay after the engine rejuvenation treatment at 3M. Has been a struggle to upload the pics hence only one. Hope it's of use to you. Regards, SS |
![]() | ![]() |
|
![]() | #39 | |
BHPian ![]() | ![]() Quote:
This might be a dumb question but how does engine coating treatment help? Does it help in less dust collection in the engine bay? Any other advantages of doing this? | |
![]() |
![]() | #40 |
BHPian ![]() | ![]() Hi FiFan, Yes! It prevets dust collection and more importantly makes cleaning easier. Also supposed to protect the rubber and plastic parts to a certain extent. Also, the chemical used is supposed to keep rats - who chew your wires - at bay. Finally, it looks good - ![]() Regards, SS |
![]() |
![]() | #41 |
BHPian ![]() | ![]() @raj akshay1234, f1fan and others I would like to Under-body coating done for 7year old 800 the under-body has started to show signs of superficial rust although had done anti-rust coating at time of delivery from Sai-Service in 2005 but i think the coating was not done properly. But many have mentioned here that borivali outlet does n have ramp or lift to lift the car up and they rely on jacks and L nozzle. So does it make sense to go to 3M official center or to go to Maruti A.S.S for the under-body coat using 3M product or to get it done locally with sourcing the 3M under-body coar cans from opera house ? For detailing i want to call Kamyo home for my 800 and also civic but running tap or hose water is an issue. |
![]() |
![]() | #42 |
Senior - BHPian ![]() Join Date: Jan 2008 Location: Dubai/Mumbai
Posts: 5,196
Thanked: 2,727 Times
| ![]() |
![]() |
![]() | #43 |
BHPian Join Date: May 2007 Location: Navi Mumbai
Posts: 184
Thanked: 46 Times
| ![]() Good news for Navi Mumbai'tes: A new 3M car care outlet opened on Palm Beach Road, Nerul (at the Signal near Sec 48). Noticed yesterday night while driving by. |
![]() | ![]() |
![]() | #44 | |
Team-BHP Support ![]() ![]() Join Date: Dec 2006 Location: Mumbai
Posts: 10,100
Thanked: 9,619 Times
| ![]() Quote:
Kamyo doesn't need running water as such. They just need to fill up their buckets. If you can provide that much then all will be fine. | |
![]() |
![]() | #45 | |
BHPian ![]() | ![]() Quote:
You went to borivali place right ?? Oh so if kamyo can work with buckets then that i can provide very well no issues. Will getting my 800 and civic detailed by them sometime next month. | |
![]() |