![]() |
Originally Posted by karankapoor
(Post 1303138)
i don't no whether this is a amp problem or gains are not set accordingly or the enclosure is not made properly. and no the amp is not to small for the subs as they can take upto 1kw power and the amp is rated as 1.5 kw @ 2 oh so 750 wrms is sufficient for them. but how he was using it. no i don't think that is the reason he selling it. |
Originally Posted by chiragh_bir
(Post 1302951)
There is one Strange problem which was told by some one.. According to him as soon as JBL 7001 hits peak power the Bass level comes down , How true is that? |
Originally Posted by panky12345
(Post 1303179)
Did you do a sufficient research on the situation as a whole? what is the volume of the enclosure, amp and sub RMS ratings etc. |
Originally Posted by karankapoor
(Post 1303138)
no i don't think that is the reason he selling it. |
Originally Posted by navpreet318
(Post 1303209)
power cables.Now why is giving me an indication that its ONLY due to the power cable! ;) See chiragh i told you.here is your answer.^ thanks hydrashok |
Originally Posted by abhinav.gupta88
(Post 1303220)
Chiragh, why disclosed man. Yes, selling cause i'm moving abroad for a year or so. Will buy subs/amps after i come back. Vitamin M Saving uptil then. :) Till then I'm enjoying the GZ Compos and JBL Amp. P.S. An Update in that department coming pretty soon. :) |
Originally Posted by hydrashok
(Post 1303200)
Not completely relevant to the discussion, but I've seen & heard of this happening when the amp is not getting proper input power. An amp+sub combo will be booming away merrily till somebody pushes the volume up and then the bass levels come down. I saw this happening a few weeks back at an install, and the installer replaced the power wire to good quality ones, and of the right gauge (the same guage, in this case). The setup was running BOSS wires of 4 guage (according to BOSS) and powering an amp/sub combo running at 2 ohms. The wiring was changed to 4 guage Kicker wire (apparently the amp needed only 4 guage for the power it was putting out) and the problem was solved. I don't remember what equipment (amp/sub) was involved here, or what the power levels were, but I do know that the problem was solved with the power wire replacement. |
Originally Posted by navpreet318
(Post 1303209)
power cables.Now why is giving me an indication that its ONLY due to the power cable! ;) See chiragh i told you.here is your answer.^ thanks hydrashok |
Originally Posted by low_bass_makker
(Post 1303785)
Just for the record Abhinav is using finolex 50 mmsq (zero gague) power cable. Hydra it was not the cable fault. We check other amps on the same setup and they played fine...We even tried playing the amp on 4 ohms loads but still the output was reduced (the amp was only reducing the volume not tripping or full shutting down or going into protection). The gains were set properly no issues with that as I was the one who adjusted them. |
Originally Posted by chiragh_bir
(Post 1303808)
but why this problem? |
Originally Posted by karankapoor
(Post 1303828)
+2 ^^^ but why never heard it before, only abhinav has complained about this |
Originally Posted by abhinav.gupta88
(Post 1303248)
...It was not the cable issue definitely. |
Originally Posted by low_bass_makker
(Post 1303785)
Just for the record Abhinav is using finolex 50 mmsq (zero gague) power cable. Hydra it was not the cable fault. ... |
All times are GMT +5.5. The time now is 19:05. |