Team-BHP - Oil consumption in a Baleno

Calling all Baleno owners Vp13, mclaren and the rest. I normally service my car every 5000 kms and find that the oil level is close to the lower indicator at the end of 5000 kms (it is midway after the service). Is this normal? And what is the viscosity grade specified by Maruti for a place like Mumbai?

buddy your engine is consuming oil for sure . please check if it is a leak or if its oil burning. get the spark plugs checked. are any gaskets leaking? did you change the type of oil? mineral to semi synthetic to synthetic? was any work done on engine and its accessories in past? how does the engine sound these days?
check if the oil filter is installed properly and the oil drain plug is tight enough. lift the car at any local car wash shop and do under car inspection before washing. wet marks around should show up. while under the car check at the small hole on gearbox at its lower side for mud accumulation near the small vent. this can tell if the engine rear bearing seal is leaking. i had this trouble last week.

Quote:

Originally Posted by Floyd de Souza (Post 498749)

No matter which car - :Shockked: NO CAR is supposed to consume oil in the normal course of running. 5k is normal service interval mileage (could also be longer). There is something more to it. It merits an inspection by your MASS at the earliest.

What's method that you use to check the oil level ? I mean do you check it when the engine is cold OR when the engine has been brought up to normal running temp.?
What does the service manual say ?

Thanks,
rb2399

Quote:

Originally Posted by Ricky_63 (Post 499368)

NO CAR is supposed to consume oil in the normal course of running. 5k is normal service interval mileage (could also be longer). There is something more to it. It merits an inspection by your MASS at the earliest.

All engines consume oil. The quantum depends on engine size and running conditions. I haven't noticed any oil leak as such and the engine sounds fine. The exhaust at start-up too is fine. As some of you said, it may be that there may be a barely noticeable leak. I shall ask the dealer to check at the next service. Thanks to all of you for your replies. And yes the grade is 20W40.

Quote:

Originally Posted by rb2399 (Post 499682)

U need to check when the engine is cold.. basically when the oil has settled down.

Also, when we switch to synthetic, Do we need to flush out the existing engine oil ? I don't think we can top up .. right?

Quote:

Originally Posted by Floyd de Souza (Post 498749)

5k is just too little for so much oil to be consumed

and also 5k is too little for an oil change unless ur time duration is over 4 months for this mileage.

Quote:

Originally Posted by Floyd de Souza (Post 499742)

All engines consume oil. The quantum depends on engine size and running conditions. I haven't noticed any oil leak as such and the engine sounds fine. The exhaust at start-up too is fine. As some of you said, it may be that there may be a barely noticeable leak. I shall ask the dealer to check at the next service. Thanks to all of you for your replies. And yes the grade is 20W40.

Well in which case my cars are "different" - coz they do not consume oil. :) I still think you should get it checked. Your call sire !!