Team-BHP
(
https://www.team-bhp.com/forum/)
Quote:
Originally Posted by amitk26
(Post 1921158)
Just one more info , BEML Campus is visible from my office building and they have a batch of new Stallion trucks ( more then 50 as of today) standing in yard. The daily production adds to the numbers in this yard and one fine day when yard is full all of them suddenly disappear
BEML manufactures railway coach and Tetra trucks but I have seen many times batches of Stallions also don't know what is the deal. |
Quote:
Originally Posted by hvkumar
(Post 1921173)
|
Ya I also found similar links , will try to look closely if the label is Stallion or not though It is impossible to see from the distance.
Any way for earlier batches I am pretty sure that I saw Stallion written on some of the truck exiting BEML gate. There are some bloated rounded metallic superstructure kind of things lying around in ground which are fitted on trucks , so may be they just come for fixing them.
Quote:
Originally Posted by amitk26
(Post 1921195)
.... so may be they just come for fixing them. |
Yes. Stallions are not produced by BEML and are produced only from Hosur plant of AshokLeyland. They are further moved to BEML for other aggregate fitments.
I write from personal experience. We were donated a AL Cargo ( IVECO) 709 Cabin and chassis in Dec 2005. We built a special mobile clinic with a highly specialized internal suspension to carry some very expensive medical equipment. The vehicle runs 25 days a month on a circular route using NH, state highways, ghat roads, mining areas ( no roads :Shockked:) and village roads covering close to 4500 kms.
The vehicle has been performing brilliantly since Feb2006, 52 months and going strong.
The odo had some 21000 km on delivery as it was some test/demo vehicle. It has been serviced only by Sundaram Motors at Bangalore. Recently did a engine overhaul costing about 42k including spares @ 250,000 km.
apart from this there have been tyre changes, oil changes and air filter cleaning at regular intervals.
We were apprehensive over cost of repairs and spares, but happily over the last 4 years its been a dream run.
Though I personally have driven the vehicle for short ( 5 - 10 km) distances, the vehicle feels planted and sure.
Our additional vehicle now is a Eicher Cruiser bus pre built 42 seater. If I had a choice I would go AL way every time.
Quote:
Originally Posted by skrao
(Post 1923477)
Our additional vehicle now is a Eicher Cruiser bus pre built 42 seater. If I had a choice I would go AL way every time. |
You mean you aren't very happy with the Eicher?
Had an interesting discussion with a long distance trucker (Gonda-Bangalore) last night.
He was of the opinion that people buy Tata owing to its better mileage and lower cost of spares compared to AL. He was driving a 2515C costing 21 lacs OTR Rewa.
Other details that could be interesting:
Mileage: 4 kmpl (Drivers say 3.5 to make some money)
Kilometers clocked: 1.1 lac in 18 months
Issues: None since no overloading is permitted by his owner. Only 16 tons plus 9 tons tare.
Tires: Radial. A pair cost 32k.
Tank capacity: 360 litres.
Rate: 45000INR from Gonda to Bangalore (2500km one way).
PS: The truck was exceedingly well maintained with no dents, cuts, increased leaves in the springs etc. He also told me that this vehicle would be sold by the owner for a new one in the next 18 more months and would fetch around 12 lacs then.
One thing I've personally noticed is that Tata CVs tend to have better ergonomics than the counterpart AL CVs. For ex: In a AL bus, you see the driver sitting slightly offline from the steering, in contrast to one in a Tata bus who sits like we normally do. (Check picture of the Aishwarya travels (Raj_5004's ?) bus)
Quote:
Originally Posted by amitk26
(Post 1926334)
Did any one here spotted those Tata World truck on Indian roads till date ? Or we are still smaller truck market ? |
According to some reports i read, they do sell World truck in India, but not available off the shelf (need to be pre-ordered). Some of the big trucking companies in India ordered these trucks in large numbers, due to capacity constraints, the waiting period is quite high right now. Since these are expensive, TM is not expecting these to be baught by small operators (that owns 1/2 trucks).
Quote:
Originally Posted by prashanthyr
(Post 1926575)
One thing I've personally noticed is that Tata CVs tend to have better ergonomics than the counterpart AL CVs. For ex: In a AL bus, you see the driver sitting slightly offline from the steering, in contrast to one in a Tata bus who sits like we normally do. |
Personally, I've always felt the other way. The steering used to be much off-set earlier. Its better these days. From what I see daily on KeSRTC buses, the Leyland steering being higher, lets the drivers have a much more comfortable seating position.
In case of TATAs' tall drivers have their thighs rubbing with the steering when their try raising the seat. Some time back, we had images in on T-BHP showing ergonomics of seating TATA v/s Leyland. Not sure which thread are those posts now in.
Quote:
binaiks : In case of TATAs' tall drivers have their thighs rubbing with the steering when their try raising the seat.
|
The seats are adjustable for height. Not the motorized type like we see on cars, but a purely mechanical setup.
Also, it is not about tall / short as much as about the driver's build - slim or stocky.
Moreover, most HCV seats are made by the body builder/coach builder and are hence not a constraint to making it comfortable.
Quote:
Originally Posted by n.devdath
(Post 1927926)
Moreover, most HCV seats are made by the body builder/coach builder and are hence not a constraint to making it comfortable. |
AFAIK, the coach builders do not touch the driver's seat, it is the one which comes with the manufacturer.
Quote:
Originally Posted by raj_5004
(Post 1927991)
AFAIK, the coach builders do not touch the driver's seat, it is the one which comes with the manufacturer. |
In south India, sometimes drivers use the seats from manufacturers from what I have seen. Go up north and you will see most seats built according to the driver/owner's requirements, be it buses or trucks.
I wonder how drivers live with the netted seats that AL offers and those horrible black belted seats that TATA offers on most of its vanilla chassis configurations.
Quote:
Originally Posted by prashanthyr
(Post 1926575)
One thing I've personally noticed is that Tata CVs tend to have better ergonomics than the counterpart AL CVs... |
I too felt its the other way around. Just check the steering wheel of AL FES and Tata's. It will be easily evidenced.
Even I spoke to several drivers here in MTC and it was endorsed by them.
All times are GMT +5.5. The time now is 00:49. | |