BHPian
Join Date: Aug 2011 Location: North America
Posts: 270
Thanked: 141 Times
| Re: Shocked! Another car with my number! The following is an extract from the Tamil Nadu Government request for bid on HSRP plates available at http://www.tn.gov.in/sta/Bid_document.pdf Quote:
SECTION - V
SPECIFICATION OF THE HIGH SECURITY REGISTRATION PLATES
The Size and Technical Specifications of the High Security Registration Plates shall be as per the G.S.R. No.221 (E) dated 28.03.2001 and SO 814 (E) dated 22.8.2001 and SO 1041 (E) dated 16.10.2001 notified in the Gazette of India (Notifications are attached)
Extract of :
MINISTRY OF ROAD TRANSPORT AND HIGHWAYS
NOTIFICATION
New Delhi, the 28th March, 2001
G.S.R. 221 (E). – Whereas the draft of certain rules further to amend the Central Motor Vehicles Rules, 1989 were published as required by sub-section (1) of section 212 of the Motor Vehicles Act, 1988 (59 of 1988) with the notification of Government of India in the Ministry of Road Transport and Highways. No. G.S.R. 948 (E), dated the 29th December, 2000 in the Gazette of India, Extraordinary, Part II, Section 3, Sub-section (i), dated the 29 December, 2000 inviting objections and suggestions from all persons likely to be affected thereby within a period of 30 days from the date on which copies of the Gazette of India in which the said notification was published, were made available to the public;
And, whereas the copies of the said Gazette were made available to the public on 2nd January, 2001;
And, whereas the objections and suggestions received from the public on the said draft rules have been considered by the Central Government;
Now, therefore in exercise of the powers conferred by sections 8, 9, 11, 12, 15, 17, 19, 27, 44, 47, 49, 51, 54, 56, 64, sub-section (14) of section 88 and section 110 of the said Act, the Central Government hereby makes the following rules further to amend the Central Motor Vehicles Rules, 1989, namely :-
(1) These rules may be called the Central Motor Vehicles (1st Amendment) Rules, 2001.
(2) They shall come into force from the date of their final publication in the Official Gazette except clause (1) of sub-rule (8), sub-rule (17), sub-rule (18) which shall come into force after six months the date of such publication, and sub-rule (22) shall come into force on 1st October, 2002.
In the Central Motor Vehicles Rules, 1989.
(8) in rule 50,
(a) for sub-rule(1), the following sub-rule shall be substituted, namely :-
“(1) On or after commencement of this rule, the registration mark referred to in sub-section (6) of section 41 shall be displayed both at the front and at the rear of all motor vehicles clearly and legibly in the form of security license plate of the following specifications, namely :-
(i) the plate shall be a solid unit made of 1.0 mm aluminium conforming to DIN 1745/DIN 1783 or ISO 7591. Border edges and corners of the plate shall be rounded to avoid injuries to the extent of approx. 10mm and the plates must have an embossed border. The plate shall be suitable for hot stamping and reflective sheet has to be guaranteed for imperishable nature for minimum five years. The fast colouring of legend and border to be done by hot stamping.
(ii) The plate should bear the letters “IND” in blue colour on the extreme left center of the plate. The letter should be one fourth of the size of
letters mentioned in rule 51 and should be buried into the foil or applied by hot stamping and should be integral part of the plate;
(iii) each plate shall be protected against counterfeiting by applying, chromium-based hologram, applied by hot stamping. Stickers and
adhesive labels are not permitted. The plate shall bear a permanent consecutive identification number of minimum seven digits, to be laser branded into the reflective sheeting and hot stamping film shall bear a verification inscription;
(iv) apart from the registration marks on the front and rear, the third registration mark in the form of self destructive type, chromium
based hologram sticker shall be affixed on the left-hand top side of the windshield of the vehicle. The registration details such as registration number, registering authority, etc., shall be printed on the sticker. The third registration mark shall be issued by the registering authorities/approved dealers of the license plates manufacturer along with the regular registration marks, and thereafter if such sticker is destroyed it shall be issued by the license plate manufacturer or his dealer;
(v) The plate shall be fastened with non-removable/non-reusable snap lock fitting system on rear of the vehicle at the premises of the registering authority;
The license plates with all the above specifications and the specified registrations for a vehicle shall be issued by the registering authority or approved the license plates manufacturers or their dealers. The Central Road Research Institute, New Delhi or any of the agency authorized by the Central Government shall approve the license plates manufactures to the above specification;
(vi) the size of the plate for different categories of vehicles shall be as follows:-
For two and three wheelers - 200 X 100 mm
For Light Motor Vehicles/passenger cars – 340 X 200 mm/500 X 120 mm
For medium commercial vehicles, heavy commercial vehicles and Trailer/combination – 340 X 200 mm:”
Provided that this sub-rule shall apply to already registered vehicles two years from the date of commencement.”
(b) in sub-rule (2), for clause (d), the following shall be substituted, namely :-
“(d) the letters of the registration mark shall be in English and the figures shall be in Arabic numerals and the letters and figures shall be embossed and hot-stamped and shall be shown :-
(A) in the case of transport vehicles in Black colour on yellow background ; and
(B) in other cases, in Black colour on While background, the registration mark on the trailer shall be exhibited on the left hand side in Black colour on yellow background. In addition, the registration mark of the drawing vehicle shall be exhibited on the trailer also and this shall be done on the right hand side at the rear of the trailer or the last trailer as the case may be, in Black colour on retro-reflective type yellow background”;
|
Rest of the SOs also do not mention the necessity of prefixing zeros when the numerals are less than 1000. The SOs are also available in the same link.
Mods: Please merge my posts if possible. Thanks!
Last edited by SedatedDrive : 7th October 2014 at 05:08.
|