Some details on the Jimny Rear Trackbar Relocation Bracket

Panhard bar / trackbar risers are generally are three kinds based on how it goes on the stock riser.

BHPian Sankar recently shared this with other enthusiasts:

There is some confusion here regarding the same because of the captive nut on the 5 door's rear axle. All Gen 4 Jimny's, 3 door and 5, have the same rear axle and the same captive nut to secure the trackbar to the rear axle. All Gen 4 Jimny trackbar relocation brackets fit the 5 door. Even Gen 3 axles have same captive nut on the stock riser. Some risers are made to fit both Gen 3 and Gen 4 axle, the only difference is the location and size of two small holes on the side of the bracket.

Panhard bar / trackbar risers are generally are three kinds based on how it goes on the stock riser.

1. Overlaps the stock riser at both front, rear and LHS and has somewhat of an more elaborate fitting. Eg: OME, MF etc.
2. The other type overlaps the stock riser at the rear and LHS and the front part goes inside the stock riser. Eg: Taniguchi, Showa garage, Masterpiece, Hardrace etc.
3. The type that sits inside the stock riser completely front, rear and LHS. Eg: Xshock dakar, 4xForza (which is inspired by Xshock) etc.

A Taniguchi trackbar riser bracket installed on the Jimny 5 door.

Check out BHPian comments for more insights and information.