[adityamunshi]

Did you buy it or DIY ?

Originally Posted by moralfibre

I did change the sub enclosure long time back when I got the HU. I have a 1 cu.ft sealed enclosure now.

[moralfibre]

Originally Posted by adityamunshi

Did you buy it or DIY ?

I bought it. Its from a company called Bassworks which makes these enclosures in Chennai.

5440-10231.jpg - 2000 Maruti Esteem VX The Night Rider

4839-8234.jpg - 2002 palio 1.2ELX

[payam]

Originally Posted by moralfibre

4839-8234.jpg - 2002 palio 1.2ELX

Looks so familiar to me

[razor4077]

Originally Posted by moralfibre

I bought it. Its from a company called Bassworks which makes these enclosures in Chennai.

Have a Bassworks sub enclosure too. Very good quality. Cost me 1500 bucks.

[amit_mechengg]

Originally Posted by kumar_ranjan

I agree with you that we have the same car. I have a 2 channel amp that I plan to use to power it. I was just confused between illusion EL12 used by Kiran and GZTW 30T. I have made up my mind for GZ .

what watts do u have on ur 2 channel amp. believe me 150 watts RMS cannot power any sub to its full potential. i have tried 3 amps of 3 different makes. finally i landed up selling everything and buying jbl 75.4 amp. 284 watts RMS.
it makes a world of difference

[kumar_ranjan]

Originally Posted by amit_mechengg

what watts do u have on ur 2 channel amp. believe me 150 watts RMS cannot power any sub to its full potential. i have tried 3 amps of 3 different makes. finally i landed up selling everything and buying jbl 75.4 amp. 284 watts RMS.
it makes a world of difference

I am using Panasonic CY-PA2003U Amps. The specs are as follows:

RMS Power (4 Ohms): 200 x 2 Watts
Power at 2 Ohms: 600 x 2 Watts
Bridged Power: 1200 Watts
Bass Boost: 0-15dB
Channel Operation: 2
Signal-to-Noise: 85dB
Frequency Response: 10Hz-30kHz

I guess in Bridged mode 4 Ohms RMS would be 350+

[amit_mechengg]

Originally Posted by kumar_ranjan

I am using Panasonic CY-PA2003U Amps. The specs are as follows:

RMS Power (4 Ohms): 200 x 2 Watts
Power at 2 Ohms: 600 x 2 Watts
Bridged Power: 1200 Watts
Bass Boost: 0-15dB
Channel Operation: 2
Signal-to-Noise: 85dB
Frequency Response: 10Hz-30kHz

I guess in Bridged mode 4 Ohms RMS would be 350+

great amp that is. then u got the power to fire almost anything. where did u get the panasonic from? i was too looking at the panasonic 1200 watts RMS.

[kumar_ranjan]

Originally Posted by amit_mechengg

great amp that is. then u got the power to fire almost anything. where did u get the panasonic from? i was too looking at the panasonic 1200 watts RMS.

Thanks. I had purchased the Amps from Bhandari Car Accessories located on JM road pune. You can call them ask for 1200 Watts RMS AMPS. The contact number is:
020 - 553 5323, 553 3427,
Mob: 9822097547

[mohang_j]

Where do i get JBL CS1204 woofer parameters,i could not find it in JBL website.Can somebody help.Also how do we reduce port length - i am building wedge shaped box and 4 inch/13.XX inch port will be very lengthy.

[amit_mechengg]

Originally Posted by mohang_j

Where do i get JBL CS1204 woofer parameters,i could not find it in JBL website.Can somebody help.Also how do we reduce port length - i am building wedge shaped box and 4 inch/13.XX inch port will be very lengthy.

hey just design a box that is similar to JBL Bass Reflex box. i have put my gt5-12" in the same box. it works amazing. i am waiting for mu GZ MK2 sub. that too i will be putting in the same box.

[moralfibre]

Originally Posted by mohang_j

Where do i get JBL CS1204 woofer parameters,i could not find it in JBL website.Can somebody help.Also how do we reduce port length - i am building wedge shaped box and 4 inch/13.XX inch port will be very lengthy.

Originally Posted by amit_mechengg

hey just design a box that is similar to JBL Bass Reflex box. i have put my gt5-12" in the same box. it works amazing. i am waiting for mu GZ MK2 sub. that too i will be putting in the same box.

Don't build a Bass Reflex box. And Amit, I have time and time again tried to explain that your box is NOWHERE close to what a Bass Reflex box from JBL is. If you do not believe me, please open the box to see what is inside. They are cheap after market lookalikes and the similarity ends there. Most people on the forum would always prefer to put the sub in a sealed enclosure.

mohang_j, PM Sam Kapasi for details of enclosure options for the JBL CS1204. He will provide you with the exact enclosure dimensions for your sub.

[amit_mechengg]

Originally Posted by moralfibre

Don't build a Bass Reflex box. And Amit, I have time and time again tried to explain that your box is NOWHERE close to what a Bass Reflex box from JBL is. If you do not believe me, please open the box to see what is inside. They are cheap after market lookalikes and the similarity ends there. Most people on the forum would always prefer to put the sub in a sealed enclosure.

mohang_j, PM Sam Kapasi for details of enclosure options for the JBL CS1204. He will provide you with the exact enclosure dimensions for your sub.

can i seal the same box and use it as sealed enclosure?

[abhibh]

Originally Posted by amit_mechengg

can i seal the same box and use it as sealed enclosure?

No, please don't even think about that! Get a sealed or ported box made of MDF.

[amit_mechengg]

Originally Posted by abhibh

No, please don't even think about that! Get a sealed or ported box made of MDF.

i will get a good sealed box for GZ MK2.maybe the same as moralfibre

[moralfibre]

Originally Posted by amit_mechengg

i will get a good sealed box for GZ MK2.maybe the same as moralfibre

Poona motors / Music corner have these ready made sealed enclosure by Bassworks / BaassFx retailing for about Rs. 1,500/- for 12" subs. They also have a terminal plug making it easy for removing your sub when you have excessive luggage.