Team-BHP - VCDS (Vag-Com Diagnostic System) for VW & Skoda

- - VCDS (Vag-Com Diagnostic System) for VW & Skoda - Discussion Thread (https://www.team-bhp.com/forum/technical-stuff/152370-vcds-vag-com-diagnostic-system-vw-skoda-discussion-thread-52.html)

Quote:

Originally Posted by Sen (Post 4962429)

Awesome! Can I ask you for help then? My cable is gonna take weeks. :ZZZ:

Auto-unlock on ignition off has been disabled I think on my car already. The car doesn't unlock until a passenger pulls the door handle to leave the car.

And without request sensors, it'll be difficult managing the other occupants needing to get in or to get somehing if I enable only driver door upon remote unlock, which is something that happens to me a lot.

Quote:

Originally Posted by sivasain (Post 4962431)

Sure. I stay around whitefield side. But travelling till new years. PM me and we can sync up

Thanks for offering to help Sen. I stay in Whitefield as well, possible for me to join the meetup as well? This will be the first time for me to configure on my Skoda Fabia.

Quote:

Originally Posted by abhinavinc (Post 4970279)

Thanks for offering to help Sen. I stay in Whitefield as well, possible for me to join the meetup as well? This will be the first time for me to configure on my Skoda Fabia.

If it helps, I got my VCDS cable finally, so I haven't taken up Sivasain@'s offer. Hit me up if you're near Ecity phase 1 after 19th January! (gonna be in Hyd)

Just putting this here and hoping for the best. :)

Any BHPian in/ around Chennai with VCDS who could help out with a Polo? Specifically, to make the MID usable after 80+ kmph.

Thanks!

Request to Hyderabad BHPians, if anyone who can lend their VCDS cable so that I can make the following changes to my Vento.

Comfort turn signal to 5 clicks
Time to 24H format
Needle sweep

Unable to procure VCDS cable from Aliexpress.

Tried making the changes at PPS motors Gachibowli/Kukatpally, however, their software does not show the above changes in the system.

I can get my car for a small catchup and make the changes

Request to Ahmedabad BHPians, if anyone who can lend their VCDS cable so that I can make the following changes to my Vento 1.2 TSI as i'm unable to procure VCDS cable from aliexpress

Comfort turn signal to 5 clicks
Brake Assist to Early
Emergency Braking Flashing lights check
Reverse buzzer sound to a lower tone
Needle sweep/indicator celebration/staging on
Tear wiping

Also can't get hold of tuner in Ahmedabad who would help out.

Quote:

Originally Posted by cormodore (Post 4972118)

You're in luck! I'll be in Hyderabad from 9th - 17th Jan! Hit me up via PM. :)

PS - I tried getting the time to 24H format on my Vento, it sorta failed to do that. But trial and error is the name of the game!

Quote:

Originally Posted by Achalchoukhany (Post 4972444)

I have a VCDS cable plz DM me

Quote:

Originally Posted by Sen (Post 4972652)

You're in luck! I'll be in Hyderabad from 9th - 17th Jan! Hit me up via PM. :)

Hi Sen,

Thank you for responding. Unable to PM you as I am a newbie.

If you can PM me, pls do so. Else, request you to drop me a note to my mail id sudakr@gmail.com with your mobile number and I can connect.

Quote:

Originally Posted by SS8939 (Post 4970872)

Just putting this here and hoping for the best. :)

Any BHPian in/ around Chennai with VCDS who could help out with a Polo? Specifically, to make the MID usable after 80+ kmph.

Thanks!

Am based out of Adyar. Let me know what you need. I have a V20.4.2 cable.
Drop me a private message.

I have a 2015 HL AT Jetta. Need help with respect to the ORVMs.

I read in this thread that it is possible to Open / Close the ORVMs through the Keyfob. Please let me know if anyone has tried that.

Alternatively is it possible to Open / Close the ORVMs based on the ignition input?

Also once intpo the VCDS, am not able to access only the Instruments (I think Section # 17) section. Is anyone facing this issue?

Quote:

Originally Posted by vasanthjn (Post 4976424)

It is possible if you have a Jetta Highline with ORVM adjustment on the doorpad. I have done it on my Passat Highline - originally done on a Jetta. See https://www.team-bhp.com/forum/offic...ml#post4801639

Quote:

Originally Posted by amit_i (Post 4973265)

I have a VCDS cable plz DM me

Hello Amit, i don't have the privilege to dm other BHPians, Please contact me on 9925016620 whenever possible for you.

Thanks

Hi guys. Wanted some advice. Friend has a 2011 Polo Comfortline and wants to enable the usual bunch of features. Would you'll recommend getting a VCDS cable or an OBDeleven adapter ? Any other suggestions are welcome too.

Quote:

Originally Posted by rpunwani (Post 4976459)

Thanks a lot. I tried it today and in the first attempt it didnt work. Later when I enabled the comfort windows option, it worked. Once again thanks a lot.