Ok Navinji, LBM, here is my plan for ICE upgrade for my little Alto.
Existing.
HU – Pioneer DEH 5750MP
Front Sony 2 way Coaxial – 20W RMS (120w max)
Rear Pioneer 6 x 9 TS-A6991 80W RMS (420w max) on rear shelf.
Planned
Option 1
HU – Existing.
Front – 4” Infinity Kappa 42.7i, 50W RMS, 75hz-25Khz (INR 3,348/-)
Rear – Existing
Sony XM 554ZR - 4 channel amp for speakers, 55x4 RMS (INR 4,200/-)
JBL P1222 sub woofer, 400W RMS (INR 8,500/-) 23hz – 400hz in sealed enclosure (INR ?),
Pioneer 5300T for subwoofer, 380W RMS when bridged (INR 5,100),
Option 2
HU – Existing
Front – 4” Infinity Kappa 42.7i, 50W RMS, 75hz-25Khz (INR 3,348/-)
Rear – Existing
Sony 4 channel amp for speakers, XM 554ZR, 55x4 RMS (INR 4,200/-)
Infinity Basslink II 250W RMS active subwoofer 20-400hz (INR 14,000/-)
Option 3
HU – existing
Front – 4” components Sound stream EGC.4, 80W RMS, 90hz-20Kz (INR 5,100/-)
Rear – Existing
Kenwood KAC X40 4 channel amp for speakers, 70 x 4 RMS (INR 13,200/-)
JBL P1222 sub woofer, 400W RMS (INR 8,500/-) 23hz – 400hz, in sealed enclosure (INR ?),
Pioneer 5300T for subwoofer, 380W RMS bridged (INR 5,100)
All prices – Approximation and subjected to negotiation.
5 channel amplifiers dropped due to cost.
Howz Kicker Solobaric S12L5 sub compared to JBL P1222? Kicker's catalogue says S12L5 rated for 600W RMS with a subsonic filter tuned to 23hz. Otherwise the power handling is only 150W RMS. Quite confused. However JBL catalogue doesnt mention anything of that sort.
Amp installation kit from Monster/lighting audio/sound stream, 80A fuse near battery, one power and ground distribution block each, new speaker wires for existing ones, enclosure accessories etc (cost N/A).
Damping shall be done later (Just to feel the difference). I propose wedge shape enclosure (1cu ft inside vol w/ sub. ie. 1.2cu ft w/o sub) for subwoofer and place the woofer on the right corner (with woofer firing to the rear) in the luggage area so as to liberate maximum space. The subwoofer location shall be a permanent one.
Basslink II is already purchased. So if any other setup is selected, then I’ll dump the Basslink II. I did not like its performance anyway. My CS1200B JBL (125W RMS) sub in the other car powered by Sony XM502Z gives more punch and costs less than Basslink II.
I prefer the factory position for the front speakers. I need some MDF rings to raise the height of rear 6x9 speakers so that the magnets do not protrude into the luggage space.
Other speakers taken into considereation were - Hertz HV100 4” (75hz-10k) @ 50W RMS (+ any tweeter), MTX Tx4001 @ 75W RMS, DLS PS4A, Focal K2 Power 100KP etc. But dropped due to high price/non availability.
I would like to do the installation by myself (except for the carpentry work). Just for fun. I request Audio Gurus and fellow Tbhpians to comment on the above and advice. |